LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation, And Air Conditioning >> Repair Instructions >> Compressor Clutch Plate/Hub Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Exploded View Of Compressor Clutch Plate Assembly
    GM667064Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch coil (6) to the A/C compressor (7).
  2. Install the snap ring (5) to the clutch coil (6).
  3. Install the clutch hub/bearing assembly (4).
  4. Install the clutch hub/bearing snap ring (3).
  5. Install the clutch plate assembly (2).
    6. NOTE: Refer to Fastener Notice .
  6. Install the clutch plate retaining bolt (1).

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

    7. Fig 2: A/C Belt Tensioner
    GM370869Courtesy of GENERAL MOTORS CORP.
  7. Install a ratchet into the A/C belt tensioner adapter opening.
  8. Rotate the A/C belt tensioner clockwise in order to relieve the tension on the belt.
  9. Install the A/C belt to the A/C compressor.
  10. Slowly release the tension on the A/C belt tensioner.
  11. Remove the ratchet from the A/C belt tensioner.
  12. Install the engine protection shield.
  13. Install the bolts to the engine protection shield.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  14. Lower the vehicle.
scientia non olet · About LEMON Manuals