LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Lock Cylinder & Screws
    GM1700676Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Position the ignition lock cylinder housing to the steering column and install the 3 TORX® screws.

    Tighten:  Tighten the TORX® screws to 7 N.m (62 lb in).

  2. Install the park lock cable into the lock cylinder housing.
  3. Connect the passlock and key buzzer to the ignition lock cylinder case.
  4. Install the ignition switch. Refer to Ignition and Start Switch Replacement .
  5. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals