Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fuse & Holder

Courtesy of GENERAL MOTORS CORP.

Install the fuse to the holder.

Fig 2: View Of Generator Battery Jumper Cable & Components

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable terminal to the fuse stud.
Install the generator battery jumper cable terminal (4) to the fuse stud.

NOTE: Refer to Fastener Notice .

Install the generator battery jumper cable to fuse nut (3).
Tighten: Tighten the nut to 9 N.m (80 lb in).

Fig 3: View Of Battery Cable Components

Courtesy of GENERAL MOTORS CORP.

Install the starter solenoid cable terminal (2) to the fuse stud.
Install the starter solenoid cable nut (1) to the fuse stud.
Tighten: Tighten the nut to 9 N.m (80 lb in).

Fig 4: View Of Mega Fuse Cover

Courtesy of GENERAL MOTORS CORP.

Install the fuse cover.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .