LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Engine Cooling System) >> Repair Instructions >> Draining and Filling Cooling System >> Draining Procedure >> Filling Procedure

Filling Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The procedure below must be followed. Improper coolant level could result in a low or high coolant level condition, causing engine damage.
  1. Install the lower radiator hose to the radiator.
  2. Using the J 38185  , reposition the lower radiator hose clamp. See Special Tools .
  3. NOTE: Refer to Fastener Notice .
  4. If the left and right engine block coolant drain plugs were removed, perform the following:
    1. Apply pipe sealer to the drain plugs.
    2. Install the drain plugs.

      Tighten:  Tighten the drain plugs to 60 N.m (44 lb ft).

  5. Install the engine block coolant heater, if equipped. Refer to Coolant Heater Replacement (RPOs LC9/L76/L92)  or Coolant Heater Replacement (RPOs LY2/LMG/LY5/LY6) .
  6. Lower the vehicle.
  7. IMPORTANT: Use a 50/50 mixture of DEX-COOL antifreeze and clean, drinkable water.
  8. Slowly fill the cooling system with a 50/50 coolant mixture. Refer to Capacities - Approximate Fluid .
  9. Install the coolant pressure cap.
  10. Start the engine.
  11. Run the engine at 2,000-2,500 RPM until the engine reaches normal operating temperature.
  12. Allow the engine to idle for 3 minutes.
  13. Shut the engine OFF.
  14. Allow the engine to cool.
  15. Top off the coolant as necessary.
  16. Inspect the concentration of the engine coolant using the J 26568  . See Special Tools .
  17. Rinse away any excess coolant from the engine and the engine compartment.