LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Engine Cooling System) >> Repair Instructions >> Coolant Air Bleed Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coolant Air Bleed Hose & Throttle Body
    GM846664Courtesy of GENERAL MOTORS CORP.
  1. If necessary, remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement for the 4.8L, 5.3L, and 6.0L engines.
  2. Position the coolant air bleed hose clamp at the throttle body.
  3. Remove the coolant air bleed hose from the throttle body.
    4. Fig 2: Coolant Air Bleed Hose & Pipe
    GM790766Courtesy of GENERAL MOTORS CORP.
  4. Position the hose clamp at the pipe.
  5. Remove the coolant air bleed hose (1) from the pipe (2).
scientia non olet · About LEMON Manuals