Liftgate Actuator Switch Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Power Liftgate Switch & Screw

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the left rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter - Left (Extended Wheelbase w/E61) or Trim Panel Replacement - Rear Quarter - Left (Extended Wheelbase w/o E61) or Trim Panel Replacement - Rear Quarter - Left (Standard Wheelbase w/E61) or Trim Panel Replacement - Rear Quarter - Left (Standard Wheelbase w/o E61) .
1	Power Liftgate Switch Screw NOTE: Refer to Fastener Notice . Tighten: 7 N.m (25 lb in)
2	Power Liftgate Switch Tip: Disconnect the electrical connector. Reprogram the power liftgate actuator switch replacement. Refer to Lift Gate Control Module Programming and Setup .