Lift Gate Actuator Rod Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Liftgate Actuator Rod

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the left side trim panel. Refer to Trim Panel Replacement - Rear Quarter - Left (Extended Wheelbase w/E61) or Trim Panel Replacement - Rear Quarter - Left (Extended Wheelbase w/o E61) or Trim Panel Replacement - Rear Quarter - Left (Standard Wheelbase w/E61) or Trim Panel Replacement - Rear Quarter - Left (Standard Wheelbase w/o E61) .
1	Liftgate Actuator Rod Tip: Release the lock tabs on the actuator rod. Ensure the clip is fully seated when rod is reinstalled. If clip cannot be fully seated, a new rod should be installed.