Handle Replacement - Endgate

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Endgate Handle Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate . Remove the endgate spoiler. Refer to Spoiler Replacement - Rear (Avalanche/Escalade) .
1	Endgate Handle Bolts (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 25 N.m (18 lb ft)
2	Endgate Handle Assembly Tip: Disconnect the actuator rods.

Callout

Component Name

Preliminary Procedure

Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate .
Remove the endgate spoiler. Refer to Spoiler Replacement - Rear (Avalanche/Escalade) .

Endgate Handle Bolts (Qty: 3)

NOTE: Refer to Fastener Notice .

Tighten: 25 N.m (18 lb ft)

Endgate Handle Assembly
Tip: Disconnect the actuator rods.