Door Handle Replacement - Front Inside

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Side Door Inside Handle Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove door upper trim panel. Refer to Trim Panel Replacement - Upper Extension (Escalade) or Trim Panel Replacement - Upper Extension (Tahoe/Yukon) . Remove door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver and Door Lock and Side Window Switch Replacement - Passenger . Remove door trim panel. Refer to Front Side Door Trim Panel Replacement .
1	Front Side Door Inside Handle Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Front Side Door Inside Handle Assembly Tip: Disconnect the electrical connector. If replacing the door handle, transfer heated seat switch to new handle. Refer to Heated Seat Switch Replacement - Front (w/o KB6) .

Callout

Component Name

Preliminary Procedures

Remove door upper trim panel. Refer to Trim Panel Replacement - Upper Extension (Escalade) or Trim Panel Replacement - Upper Extension (Tahoe/Yukon) .
Remove door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver and Door Lock and Side Window Switch Replacement - Passenger .
Remove door trim panel. Refer to Front Side Door Trim Panel Replacement .

Front Side Door Inside Handle Bolt (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Front Side Door Inside Handle Assembly
Tip:

Disconnect the electrical connector.
If replacing the door handle, transfer heated seat switch to new handle. Refer to Heated Seat Switch Replacement - Front (w/o KB6) .