Scan Tool Data Definitions

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Battery Voltage Signal 2: The scan tool displays the battery voltage as seen at the liftgate module.
Hall Sensor Feed Status: The scan tool displays No Output/Short to Ground. Than scan tool will display any faults associated with the hall sensor while in motion.
Liftgate Handle Switch Status: The scan tool displays Active/Inactive. The scan tool the status of the liftgate handle switch and the liftgate close switch.
Liftgate Ajar Switch: The scan tool displays Active/Inactive. The scan tool displays the state of the liftgate ajar switch as seen at the rear integration module.
Object Detection Sensor Status: The scan tool displays the voltage as seen through the object sensors.
LGM Clutch Actuator Command: The scan tool displays Active/Inactive. The scan tool displays the commanded state of the liftgate clutch.
LGM Latch Motor Cinch Command: The scan tool displays Active/Inactive. The scan tool displays the commanded state of the cinching portion of the liftgate latch.
LGM Latch Pawl Switch: The scan tool displays Active/Inactive. The scan tool displays the state of the liftgate open switch.
LGM Latch Ratchet Switch: The scan tool displays Active/Inactive. The scan tool displays the state of the liftgate ajar switch.
LGM Motor Release Command: The scan tool displays Active/Inactive. The scan tool displays the commanded state of the release portion of the liftgate latch.
LGM Latch Sector Switch: The scan tool displays Active/Inactive. The scan tool displays the state of the liftgate conch/release switch.
LGM Motor Closed Command: The scan tool displays Active/Inactive. The scan tool displays the commanded state of the liftgate motor during closing.
LGM Motor Open Command: The scan tool displays Active/Inactive. The scan tool displays the commanded state of the liftgate motor during opening.
LGM Open/Close Position Learned: The scan tool displays Yes/No. The scan tool displays the results of the liftgate calibration.
LGM Full Open Switch: The scan tool displays Active/Inactive. The scan tool displays the status of the liftgate full open switch.