Windshield Side Reveal Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Window Side Reveal Molding, Screws & Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open the front door on the side the reveal molding is being serviced. Pull the door auxiliary weatherstrip up to the roof header. Remove the air inlet grille panel end cap.
1	Reveal Molding Nuts
2	Windshield Side Reveal Molding Tip: Upon installation, tuck the bottom edge of the reveal molding under the end cap of the air inlet grille panel prior to the screw installation.
3	Windshield Side Reveal Molding Screws (Qty: 5) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)