Sealing Strip Replacement - Rear Door Window Belt Outer (Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Outer Belt Sealing Strip

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Lower the rear side door window to the fully down position. Tape off the lower window frame to prevent damage to the door.
1	Rear Side Door Fasteners (Qty: 3) Tip: Using a suitable tool, work the tool around the upper door frame to assist in loosening the sealing strip from the door flange.
2	Rear Side Door Clips (Qty: 9) Tip: Using a suitable tool, work the tool down the front edge of the door frame to loosening the sealing strip from the door flange.
3	Rear Side Door Outer Belt Sealing Strip Tip: Pull upward to release the sealing strip from the door frame. Install the molding into the window opening by inserting the bottom legs of the molding to the door. Fully seat the molding to the belt flange between the corner of the door frame. Fully seat the molding to the upper and lower door frame and insert the fasteners and clips around the flange.