Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Open the liftgate.
- Cover the following parts to protect from broken glass:
- The upper dash pad
- The defroster outlets and A/C outlets
- The seats and the carpeting
- Remove the right or left side applique.
- Disconnect the electrical connector from the quarter window.
- If the antenna on the quarter is damaged, replace the quarter window.
- Use J 24402-A
, J 39032
, or equivalent in order to remove the quarter window. See Special Tools .
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- With the aid of an assistant, use the suction cups to remove the window from the opening.
CAUTION:
Refer to Glass and Sheet Metal Handling Caution
.
CAUTION:
Refer to Cracked Window Caution
.
IMPORTANT:
Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
CAUTION:
If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
IMPORTANT:
Keep the cutting edge of the tool against the quarter window from inside the vehicle. This will allow the urethane adhesive to be separated from the window.