Front Side Door Window Reveal Molding Replacement (Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Window Reveal Molding & Retainers

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement . Remove the outside mirror. Refer to Mirror Replacement - Power .
1	Front Side Door Window Reveal Molding Retainer (Qty: 13)
2	Front Side Door Window Reveal Molding Tip: Install the reveal molding into the window opening by inserting the bottom edges of the molding through the belt opening of the door. Allow the integral fasteners and clips to clear the door frame. Fully seat the molding onto the belt flange between the corners. Install the remaining 7 clips around the window flange.

Callout

Component Name

Preliminary Procedures

Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
Remove the outside mirror. Refer to Mirror Replacement - Power .

Front Side Door Window Reveal Molding Retainer (Qty: 13)

Front Side Door Window Reveal Molding
Tip:

Install the reveal molding into the window opening by inserting the bottom edges of the molding through the belt opening of the door. Allow the integral fasteners and clips to clear the door frame.
Fully seat the molding onto the belt flange between the corners.
Install the remaining 7 clips around the window flange.