LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Fixed & MOVEABLE Window Systems) >> Diagnostic Information and Procedures >> DTC B3822 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the right rear window switch connector and connect a test lamp from the up signal circuit to ground.
  2. Ignition ON, verify that the test lamp illuminates when the right rear up switch on the DDS is activated.
    • If the test lamp does not illuminate test the right rear window up signal circuit for a short to ground. If the circuit tests normal replace the BCM.
  3. If the circuits test normal replace the right rear window switch.