LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Switch Cancel Cam Position Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
    2. IMPORTANT: Let the SIR coil hang freely after removal.
  2. Remove the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  3. Remove and discard the bearing retainer using J 23653-SIR  and J 42137  . See Special Tools .
    4. Fig 2: View Of Steering Column Shaft Assembly Components
    GM1702353Courtesy of GENERAL MOTORS CORP.
  4. Remove the following parts from the steering column shaft assembly:
    1. Turn signal switch cancel cam plate (2)
    2. Turn signal switch cancel cam (3)
scientia non olet · About LEMON Manuals