LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Switch Cancel Cam Position Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Column Shaft Assembly Components
    GM1702353Courtesy of GENERAL MOTORS CORP.
  1. Install the following parts onto the steering column shaft assembly:
    1. Lubricate the turn signal cancel cam (3) with GM P/N 12377900 (Canadian P/N 10953529).
    2. Turn signal switch cancel cam plate (2)
    2. Fig 2: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS CORP.
  2. Install the new bearing retainer onto the steering shaft assembly.
  3. Compress the cam orientation plate using J 23653-SIR  and J 42137  . See Special Tools .
  4. Firmly seat the bearing retainer into the groove on the steering shaft assembly.
  5. Remove J 23653-SIR  .
  6. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals