LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Steering Wheel & Steering Column) >> Repair Instructions >> Lower Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The upper intermediate shaft to lower intermediate shaft pinch nut is held by a keeper and not to be tightened. To obtain proper torque, tighten at the pinch bolt.
  1. Position the upper end of the lower intermediate shaft into the upper shaft.
    2. Fig 1: View Of Upper & Lower Intermediate Shafts & Components
    GM1701888Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt and nut.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Position the intermediate shaft to the steering gear.

    If you are reinstalling the same shaft, align the marks made during the removal procedure.

  4. Install the intermediate shaft to steering gear pinch bolt.

    Tighten:  Tighten the steering gear pinch bolt to 47 N.m (35 lb ft).

    5. Fig 2: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  5. Remove the J 42640  from the steering column lower access hole.
scientia non olet · About LEMON Manuals