LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Steering Wheel & Steering Column) >> Repair Instructions >> Linear Shift Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the steering column. Refer to Steering Column Replacement .
  3. Remove the shift lever. Refer to Shift Lever Replacement .
  4. Disconnect the park lock cable assembly (1).
  5. The steering column lock cylinder set should be in the OFF-LOCK position.
  6. Insert a small screwdriver into the slot on the ignition lock cylinder case and push against the locking tab to remove.
    7. Fig 2: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use excessive force when removing the automatic transmission shift lock control from the steering column. Using excessive force may cause damage to the automatic transmission shift lock control and/or the steering column.
  7. Use a small screwdriver to pry the automatic transmission shift lock control from the linear shift assembly.
    8. Fig 3: View Of Linear Shift Assembly And Retaining Screws
    GM662202Courtesy of GENERAL MOTORS CORP.
  8. Remove the 3 TORX® screws from the linear shift assembly.
  9. Remove the linear shift assembly from the steering column support assembly.
scientia non olet · About LEMON Manuals