LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Steering Wheel & Steering Column) >> Repair Instructions >> Linear Shift Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Linear Shift Assembly And Retaining Screws
    GM662202Courtesy of GENERAL MOTORS CORP.
  1. Install the linear shift assembly onto the steering column support assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Secure the linear shift assembly to the steering column assembly with the 3 flat head tapping screws.

    Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.

    Tighten:  Tighten the 3 TORX® screws to 10 N.m (89 lb in).

    3. Fig 2: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic transmission shift lock control to the linear shift assembly.
    4. Fig 3: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
  4. Connect the park lock cable assembly (1) to the ignition lock cylinder case in the following way:
    1. Place the steering column lock cylinder set into the OFF position.
    2. Place the shift lever clevis into the Park position.
    3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
  5. Install the shift lever. Refer to Shift Lever Replacement .
  6. Install the steering column. Refer to Steering Column Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals