LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> DTC B3567 >> Circuit/System Description

Circuit/System Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The driver information switches are normally open momentary switches. Power is provided to the driver information center (DIC) switches via the instrument panel cluster (IPC) ignition 1 voltage circuit. The IPC ignition 1 voltage circuit is fused in the body control module (BCM). The IPC interfaces with the DIC switches via 3 discreet circuits. The switch input to the cluster is pulled low or grounded when a switch is activated. The IPC reads the voltage at the analog input to determine which switch(es) is pressed. The switch input to the cluster is set up in a resistor ladder format. The DIC switches include the PERSONALIZATION, SET/RESET, TRIP/FUEL, AND VEHICLE INFO switches. A stuck switch or a short to battery sets a DTC.

scientia non olet · About LEMON Manuals