LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> Chime Always On >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, headlamp switch OFF, verify the scan tool Headlamp Switch parameter is Inactive.
    • If not Inactive, test the headlamps signal circuit for an open or short to voltage. If the circuit tests normal, replace the headlamp switch.
  2. Ignition ON, park lamp switch OFF, verify the scan tool Park Lamp Switch parameter is Inactive.
    • If not Inactive, test the park lamp switch signal circuit for an open or short to voltage. If the circuit tests normal, replace the headlamp switch.
  3. Ignition OFF, key out of the ignition, verify the scan tool Key In Ignition Status parameter is Key Out.
    • If not Key Out, test the key in ignition switch signal circuit for an open or short to voltage. If the circuit tests normal, replace the ignition switch.
  4. Ignition ON, doors closed, verify the scan tool Door Ajar Switch parameters are Inactive.
  5. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals