Fasten Safety Belt Warning

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The chime producer activates the fasten safety belt audible warning as requested by the body control module (BCM). The BCM sends a GMLAN message to the audio amplifier indicating the chime frequency at a slow rate and a duration of 8 seconds. The fasten safety belt warning sounds and the fasten safety belt indicator illuminates when the following occurs:

The ignition switch transitions to ON.
The inflatable restraint sensing and diagnostic module (SDM) detects that the drivers seat belt is not buckled and the signal is low. The SDM sends a GMLAN message to the BCM indicating the seat belt status. The instrument panel cluster (IPC) receives a GMLAN message from the BCM indicating the driver seat belt status.

If the seat belt is buckled when the ignition is turned ON, the chime does not sound. If the seat belt is buckled while the chime is sounding, the chime stops. If the seat belt is unbuckled after the initial transition to ON, the chime does not sound.