LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Mode Door Replacement - Upper >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of HVAC Module Assembly
    GM962571Courtesy of GENERAL MOTORS CORP.
  1. Install the lever (7) to the upper mode door/upper HVAC module case (6).
  2. Install the HVAC module assembly halves.
    3. NOTE: Refer to Fastener Notice .
    IMPORTANT: For every heat stake removed ensure that you install a screw.
  3. Install the screws to the HVAC module assembly.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  4. Install the mode actuator to the HVAC module assembly.
  5. Install the screws to the mode actuator.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  6. Connect the electrical connector to the mode actuator.
  7. Install the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
scientia non olet · About LEMON Manuals