LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Evaporator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Remove the upper radiator air baffle and deflector. Refer to Radiator Air Upper Baffle and Deflector Replacement (Cadillac) or Radiator Air Upper Baffle and Deflector Replacement (Yukon) .
  3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  4. Remove the surge tank hold down nut and bolt and position aside.
  5. Tip:  Do not open cooling system.
    6. Fig 1: View Of Evaporator Tube At Evaporator
    GM385463Courtesy of GENERAL MOTORS CORP.
  6. Remove the evaporator tube nut from the evaporator.
  7. Disconnect the evaporator tube from the evaporator.
  8. Remove the evaporator tube nut from the auxiliary A/C tube, if equipped.
  9. Disconnect the evaporator tube from the auxiliary A/C tube, if equipped.
    10. Fig 2: Evaporator Tube To Condenser
    GM363033Courtesy of GENERAL MOTORS CORP.
  10. Remove the evaporator tube nut from the condenser.
  11. Disconnect the evaporator tube from the condenser.
  12. Remove the evaporator tube from the vehicle.
  13. Discard all of the used sealing washers. Cap all of the open connections.
scientia non olet · About LEMON Manuals