LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Electrical Connector At The Blower Motor
    GM476821Courtesy of GENERAL MOTORS CORP.
  1. If equipped, remove the sound insulator panel. Refer to Instrument Panel Insulator Replacement (Cadillac) or Instrument Panel Insulator Replacement (Except Cadillac) .
  2. Remove the blower motor insulating cover screws.
  3. Disconnect the electrical connector from the blower motor.
  4. Remove the blower motor insulating cover.
    5. Fig 2: Turning Blower Motor Counterclockwise
    GM382501Courtesy of GENERAL MOTORS CORP.
  5. Pull the retaining tab down while turning the blower motor counterclockwise in order to disengage the blower motor from the heater/ventilation module.
    6. Fig 3: View Of Blower Motor (Delphi)
    GM382496Courtesy of GENERAL MOTORS CORP.
  6. Remove the blower motor.
scientia non olet · About LEMON Manuals