LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Blower Motor (Delphi)
    GM382496Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor.
    2. Fig 2: Turning Blower Assembly Clockwise (Delphi)
    GM382498Courtesy of GENERAL MOTORS CORP.
  2. Install the blower motor to the heater/ventilation module. Turn the blower assembly clockwise until the retaining tab locks into place.
  3. Install the blower motor insulating cover.
    4. Fig 3: View Of Electrical Connector At The Blower Motor
    GM476821Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the blower motor.
    5. NOTE: Refer to Fastener Notice .
  5. Install the blower motor insulating cover screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  6. If equipped, install the sound insulator panel. Refer to Instrument Panel Insulator Replacement (Cadillac) or Instrument Panel Insulator Replacement (Except Cadillac) .
scientia non olet · About LEMON Manuals