LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of A/C High Pressure Recirculation Switch
    GM1769180Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the A/C high pressure recirculation switch.

    Tighten:  Tighten the switch to 6 N.m (53 lb in).

  2. Connect the electrical connector to the A/C high pressure recirculation switch.
  3. Leak test the fittings of the components using the J 39400-A  . See Special Tools .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals