LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Right Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Correct Park Brake Cable Route
    GM1688697Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake cable taking care to correctly route the cable through the guides and the body mounts.
  2. Install the park brake cable to the backing plate by pressing the cable into place until the tabs lock into place.
  3. Install the cable to the actuator lever.
    4. Fig 2: View Of Park Brake Cable & Clips To Track Bar (W/O RPO NYS - 15 Series)
    GM555750Courtesy of GENERAL MOTORS CORP.
  4. Install the park brake cable to the track bar and secure in place with the clips. Verify the clips are installed between the locators on the track bar (1500 series).
  5. Position the park brake cable to the cable guides on the vehicle frame.
    6. Fig 3: View of Park Brake Cable & Mounting Bracket
    GM363839Courtesy of GENERAL MOTORS CORP.
  6. Install the park brake cable to the mounting bracket until the tabs lock into place.
    7. Fig 4: Identifying Right Park Brake Cable & Differential Clip
    GM366864Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  7. Install the bolt to the rear axle cable clip (2500 series).

    Tighten:  Tighten the bolt to 22 N.m (16 lb ft).

    8. IMPORTANT: After installing the cable to the rear axle holding clip, verify the clip is securely retaining the cable. If not, crimp the clip by hand taking care not to pinch or kink the cable.
  8. Install the cable to the differential clip (2500 series).
    9. Fig 5: Park Brake Cables At Equalizer Bar
    GM1471613Courtesy of GENERAL MOTORS CORP.
  9. Connect the right rear park brake cable (2) to the intermediate park brake cable (1) equalizer.
  10. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
  11. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  12. Adjust the park brake. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals