LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Guide Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake cable guide to the park brake cable.
  2. Install the park brake cable guide.
  3. Fig 1: View Of Park Brake Cable Guide Bolt (Cutaway Vehicle)
    GM1208291Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the park brake cable guide bolt to the frame.

    Tighten:  Tighten the bolt to 12 N.m (13 lb ft).

  5. Remove the safety stands.
  6. Lower the vehicle.