LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Parking Brake System) >> Repair Instructions >> Park Brake Backing Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
    2. Fig 1: View Of Park Brake Cable & Actuator Lever
    GM1688693Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the park brake cable from the park brake actuator lever.
  3. Remove the park brake shoe. Refer to Park Brake Shoe Replacement (1500 Series)  or Park Brake Shoe Replacement (2500 Series) .
  4. Remove the rear axle shaft. Refer to Rear Axle Shaft Replacement (8.6, 9.5 LD Axle) or Rear Axle Shaft Replacement (9.5 HD Axle) .
    5. Fig 2: Park Brake Backing Plate & Bolts
    GM1497147Courtesy of GENERAL MOTORS CORP.
  5. Remove the park brake backing plate bolts.
  6. Remove the park brake backing plate from the disc brake backing plate.
scientia non olet · About LEMON Manuals