LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Parking Brake System) >> Diagnostic Information and Procedures >> Park Brake Shoe Inspection

Park Brake Shoe Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Brake Dust Caution .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear brake caliper bracket with the rear brake caliper. Refer to Rear Brake Caliper Bracket Replacement (1500 Series) or Rear Brake Caliper Bracket Replacement (2500 Series) .
    4. IMPORTANT: DO NOT apply the park brake pedal with the rotors removed.
  4. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement (1500 Series) or Rear Brake Rotor Replacement (2500 Series) .

  5. Inspect and replace the park brake shoe and lining if any of the following conditions are found:
    • Excessive wear indicated by the park brake lining being worn down to the shoe
    • Park brake lining cracking
    • Oil or fluid contamination of the park brake lining
  6. Adjust the park brake shoe. Refer to Park Brake Adjustment .
  7. Install the rear brake rotor. Refer to Rear Brake Rotor Replacement (1500 Series) or Rear Brake Rotor Replacement (2500 Series) .
  8. Install the rear brake caliper with the rear brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement (1500 Series) or Rear Brake Caliper Bracket Replacement (2500 Series) .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals