LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Windshield Side Reveal Molding Replacement (Side) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Windshield Pillar Side Reveal Molding
    GM826350Courtesy of GENERAL MOTORS CORP.
  1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement - Non Functional .
  2. Remove the retaining screws.
  3. Apply outward pressure at the bottom of the windshield pillar reveal molding to release the adhesive strip.
  4. Pull the molding down to disengage the windshield pillar reveal molding from the roof rack.
  5. Remove the side reveal molding from the pillar
scientia non olet · About LEMON Manuals