Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Pillar Side Reveal Molding

Courtesy of GENERAL MOTORS CORP.

Install the windshield pillar side reveal molding to the vehicle.
Push the molding up to engage the windshield pillar reveal molding into the roof rack.
Apply inward pressure at the bottom of the windshield pillar reveal molding to wet out the adhesive strip.

NOTE: Refer to Fastener Notice .

Install the retaining screws.
Tighten: Tighten the screws to 3 N.m (26 lb in).
Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement - Non Functional .