LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Roof Rear Header Garnish Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sail Panel
    GM1412537Courtesy of GENERAL MOTORS CORP.
  1. Remove both the LH and RH sail panels. Refer to Sail Panel Molding Replacement (Left Side) .
    2. Fig 2: Center High Mounted Stop Lamp
    GM1477816Courtesy of GENERAL MOTORS CORP.
  2. Remove the two screws securing the center high mounted stop lamp (CHMSL) to the rear header garnish molding.
    3. Fig 3: Rear Header Garnish Molding
    GM1412534Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws (1) securing the rear header garnish molding (2) to the rear roof header.
  4. Release the adhesive tape from the top edge of the header garnish molding.
  5. Release the retainers from the bottom edge of the garnish molding.
  6. Remove the roof rear header garnish molding from the vehicle as the CHMSL is guided through the garnish molding opening.
  7. Clean any leftover adhesive with a 50/50 mixture of isopropyl alcohol and clean drinkable water.
scientia non olet · About LEMON Manuals