LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Roof Rear Header Garnish Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do not remove the adhesive tape backing on the rear header garnish molding until the plastic retainers are secured to the rear header panel.
  1. Position the rear header garnish molding to the rear header and guide the CHMSL through the garnish molding opening.
  2. Align the clips to the holes in the bottom side of the rear header panel.
  3. Push the garnish molding upward in order to secure the plastic retainers.
    4. Fig 1: Rear Header Garnish Molding
    GM1412534Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the screws (1) securing the rear header garnish molding (2) to the rear roof header.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  5. Release the adhesive tape backing and completely wet out the adhesive using a clean dry shop towel and the palm of the hand.
    6. Fig 2: Center High Mounted Stop Lamp
    GM1477816Courtesy of GENERAL MOTORS CORP.
  6. Install the CHMSL to the rear roof header and secure the grommet.
  7. Install the screws.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

    8. Fig 3: Sail Panel
    GM1412537Courtesy of GENERAL MOTORS CORP.
  8. Install both rear sail panel moldings. Refer to Sail Panel Molding Replacement (Left Side) .
scientia non olet · About LEMON Manuals