LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Roof Panel Joint Finish Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Preheat the sheet metal in order to melt the sealer and bond the molding into the joint. Sealer begins to flow at approximately 93°C (200°F).
  1. Use a heat gun in order to heat the cab in the joint area. Preheat the sheet metal to approximately 93°C (200°F).
  2. Install the molding.
  3. Use a roller to completely wet-out the adhesive bond.
  4. Install the luggage carrier, if equipped. Refer to Luggage Carrier Replacement (SUT) or Luggage Carrier Replacement (SUV) .
scientia non olet · About LEMON Manuals