Rocker Panel Molding Replacement (w/WS2, BVX)

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rocker Panel Molding Replacement (w/ WS2, BVX)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Open both doors on the side of the vehicle the lower rocker molding is being installed on.
1	Rocker Molding Push Pin Tip: Install the push pin after all of the clips have been secured to the body.
2	Lower Rocker Molding Tip: Align molding clips to the holes in the rocker and press the molding onto the vehicle.