LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Rear Wheel Opening Flare Replacement (SUT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheelhouse & Related Components
    GM1453833Courtesy of GENERAL MOTORS CORP.
  1. Position the wheelhouse flare (7) to the wheelhouse opening (3).
  2. Loosely install the screws.
  3. NOTE: Refer to Fastener Notice .
  4. Install and secure the lower front rocker panel retainers.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).