Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Open the liftgate.
Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .

Fig 1: Latch Cable Handle Connection

Courtesy of GENERAL MOTORS CORP.

Remove the latch cable handle connection by releasing the retainer (1) and removing the cable end from the handle arm.

Fig 2: License Plate Pocket Electrical Connectors (SUV)

Courtesy of GENERAL MOTORS CORP.

Disconnect the 2 license plate pocket electrical connectors (3).

Fig 3: License Plate Pocket Nuts (SUV)

Courtesy of GENERAL MOTORS CORP.

Remove the 6 nuts (5) retaining the plate pocket to the liftgate.
Release the 4 clips (3) retaining the license plate pocket to the liftgate (2).

Fig 4: License Plate Pocket & Liftgate (SUV)

Courtesy of GENERAL MOTORS CORP.

Remove the license plate pocket (2) from the liftgate (3).