LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Front Wheel Opening Flare Replacement (Base) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. Fig 1: Wheel Flare/Liner Retaining Screws
    GM826357Courtesy of GENERAL MOTORS CORP.
  2. Remove the retaining screws from the wheel flare and the wheel liner.
    3. Fig 2: Front Wheel Opening Flare
    GM826361Courtesy of GENERAL MOTORS CORP.
  3. Remove the push-pin retainers from the rocker protection molding.
  4. Remove the wheel flare from the vehicle.
scientia non olet · About LEMON Manuals