LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Front Wheel Opening Flare Replacement (Base) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Flare/Liner Retaining Screws
    GM826357Courtesy of GENERAL MOTORS CORP.
  1. Position the wheel flare to the vehicle.
    2. Fig 2: Front Wheel Opening Flare
    GM826361Courtesy of GENERAL MOTORS CORP.
  2. Install the push-pin retainers to the rocker protection molding.
    3. NOTE: Refer to Fastener Notice .
  3. Install the retaining screws to the wheel flare and the wheel liner.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

  4. Close and secure the hood.
scientia non olet · About LEMON Manuals