Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure that the painted surface of the endgate in the tape contact area is clean and dry.
- Peel the backing from the adhesive on the endgate cap.
- Lower the front edge of the endgate cap against the endgate surface approximately 2 mm (0.08 in) above the endgate offset.
- Rotate the endgate cap down over the top of the endgate.
- Press the endgate cap to the endgate to ensure proper adhesion.
IMPORTANT:
Do not let the tape surface contact the endgate surface until after part rotation.