LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Cargo Tie Down Loop Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the spare tire carrier.
  2. Open the endgate.
  3. Cycle the midgate window to the full down/open position.
  4. Open the midgate.
  5. Release the midgate weatherstrip from the front edge of the cargo floor liner.
    6. Fig 1: Cargo Tie Down Loops
    GM1412532Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts (1) securing the cargo box loops and liner to the floor.
  7. Remove the cargo liner from the vehicle.
  8. Invert the cargo floor liner.
    9. Fig 2: Floor Liner, Push-In Retainers, Bracket
    GM1427854Courtesy of GENERAL MOTORS CORP.
  9. Remove the push-in retainers (2) from the bracket (3) and discard.
  10. Remove the bracket (3) from the floor liner (1).
scientia non olet · About LEMON Manuals