LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Cargo Tie Down Loop Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Floor Liner, Push-In Retainers, Bracket
    GM1427854Courtesy of GENERAL MOTORS CORP.
  1. Install the bracket (3) to the floor liner (1).
  2. Install the new push-in retainers (2).
    3. Fig 2: Cargo Tie Down Loops
    GM1412532Courtesy of GENERAL MOTORS CORP.
  3. Position the cargo box liner to the floor.
  4. Install the cargo tie down loops (2).
    5. NOTE: Refer to Fastener Notice .
  5. Install the bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Reposition the midgate weatherstrip to the front edge of the cargo floor liner.
  7. Close the midgate.
  8. Cycle the window to the closed position.
  9. Close the endgate.
  10. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals