LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Exterior Trim) >> Repair Instructions >> Cargo Box Side Rail Protector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the cargo box rail protector to the cargo box rail under the lower sail panel.
  2. Secure the retainers into the body panel.
    3. Fig 1: Bed Rail Protector
    GM1412539Courtesy of GENERAL MOTORS CORP.
  3. Secure the plastic retainer to the endgate side of the bed rail protector.
  4. Position the cargo box rail to the cargo box protector.
    5. NOTE: Refer to Fastener Notice .
  5. Install the screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  6. Close the endgate.
  7. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals