LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Frame And Underbody) >> Repair Instructions >> Oil Pan Skid Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The following service procedure is for 1500 series vehicles with RPO Code NZZ.
    Fig 1: View Of Oil Pan Skid Plate & Bolts
    GM1698082Courtesy of GENERAL MOTORS CORP.
  1. Position the oil skid plate on the frame.
  2. Install the oil skid plate mounting bolts.
    NOTE: Refer to Fastener Notice .

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    3. IMPORTANT: The following service procedure is for 2500/3500 series vehicles with RPO Code NZZ.
    Fig 2: View Of Oil Pan Skid Plate & Bolts
    GM1698083Courtesy of GENERAL MOTORS CORP.
  3. Position the oil pan skid plate on the frame.
  4. Install the oil skid plate mounting bolts.
    NOTE: Refer to Fastener Notice .

    Tighten:  Tighten the bolts to 28 N.m (21 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals