LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Weatherstrip Replacement - Front Door Opening >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Pinch-Weld Flange Weatherstrip (Front Door Opening)
    GM686582Courtesy of GENERAL MOTORS CORP.
  1. Align the weatherstrip to the door opening with the 2 dots positioned on the upper right and left side.
  2. Align the weatherstrip to the door opening with the bond joint positioned at the lower center of the door opening.
  3. Install the weatherstrip to the pinch-weld flange. Ensure that the weatherstrip is fully seated.
  4. Install the front door sill plate. Refer to Front Side Door Sill Plate Replacement in Interior Trim.
scientia non olet · About LEMON Manuals