LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rubber Conduit Replacement - Rear Door

Rubber Conduit Replacement - Rear Door

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Door Conduit Grommet & Electrical Connectors
GM1674908Courtesy of GENERAL MOTORS CORP.
Rubber Conduit Replacement - Rear Door

Callout Component Name
1 Electrical Connectors
IMPORTANT: Mark the location and the color of the wires to the electrical socket before removing the wires.

Tip: 
  1. Disconnect the door wiring harness electrical connector from the body harness.
  2. Remove the wiring harness wiring one at a time from the conduit.
  3. Remove the wiring harness from the rubber conduit.
2 Rear Door Conduit Grommet
scientia non olet · About LEMON Manuals