LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rubber Conduit Replacement - Front Door

Rubber Conduit Replacement - Front Door

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Conduit Grommet & Electrical Connector
GM1674906Courtesy of GENERAL MOTORS CORP.
Rubber Conduit Replacement - Front Door

Callout Component Name
Preliminary Procedure: 
Remove the hinge pillar insulator cover. Refer to Body Hinge Pillar Trim Panel Replacement .
1 Electrical Connector
IMPORTANT: Mark the location and the color of the wires to the electrical socket before removing the wires.

Tip: 
  1. Disconnect the door wiring harness electrical connector from the body harness.
  2. Remove the wiring harness wiring one at a time from the conduit.
  3. Remove the wiring harness from the rubber conduit.
2 Conduit Grommet
scientia non olet · About LEMON Manuals